News
Primary efficiency plate filters are suitable for primary filtration in air conditioning systems, mainly used for filtration Dust particles larger than 5 μ m. There are three styles of primary filters: plate, folding, and pocket. The frame materials include paper frame, aluminum frame, and galvanized iron frame. The filter materials include non-woven fabric, nylon mesh, activated carbon filter, metal mesh, etc. The protective mesh includes double-sided sprayed wire mesh and double-sided galvanized wire mesh. So, let's learn together how to maintain and clean the primary efficiency plate filter!
Characteristics of initial efficiency plate filter:
Low price, light weight, multifunctional, compact structure.
Maintenance of primary efficiency plate filter
1. Regularly replace the high-efficiency filter according to the cleanliness of the environment (usually 1-6 months).
2. Regularly (usually every two months) use a dust particle counter to measure the cleanliness of the area where the product is used for purification. If the measured cleanliness does not match the required cleanliness, the cause should be identified (whether there is a leak, whether it is effective, etc.). If the high-efficiency filter has failed, a new high-efficiency filter needs to be replaced.
3. When replacing the initial effect filter, it should be turned off.
Cleaning Guide for Primary Efficiency Plate Filters
1. Open the suction grille of the device, press and hold the buttons on both sides, and gently pull it down.
2. Drag the hook of the air filter and pull the device down and out.
3. Use a vacuum cleaner or other equipment to remove dust or rinse with warm water.
4. If there is too much dust, you can wash it with a soft brush and neutral detergent, then air dry it with water and place it in a cool place to dry.
5. Do not use hot water above 50 for cleaning. Do not air dry on fire to avoid discoloration or deformation of the equipment.
6. After cleaning is completed, equipment needs to be installed. When installing, hang the device on the protruding part of the suction grille, fix it on the suction grille, and slowly push the rear protrusion of the suction grille inward until the entire device is pushed into the grille.
7. The next step is to close the suction grille. This is exactly the opposite of the first stage. Press and hold the filter signal reset button on the wheel, and the cleaning notification symbol will disappear.
8. In addition, there is too much dust in the environment where the super efficiency filter is used, and the cleaning frequency should be increased according to the situation. Generally, it is better to do it every six months.
The initial efficiency plate filter is a common filter we use. The primary efficiency plate filter mainly filters 5 μ m dust particles and is mainly used in commercial and industrial ventilation systems, air conditioning systems, etc. The air to be filtered enters the equipment, flows through the filtered filter, and works when it enters the sub filter or ventilation duct. The particulate impurities in the air have been blocked by the filter. However, as this operation continues to cycle, more and more particles are blocked, the filtering resistance increases, and the amount of air passing through decreases.
The above introduction is about how to repair, maintain and clean the primary efficiency plate filter. If you need to know more, please feel free to contact us at any time!